Stainless steel considerations
Stainless claddings can have a very low corrosion rate and remain functional over the life of the structure. But each stainless steel grade is a little different, so specify and use them appropriately.
This website is best viewed on a newer browser than the one you are using. Learn about upgrading your browser (opens in a new window/tab)
Welcome to BRANZ Build. Skip to main content.
Showing results 1-10 of 65
Order by:
By John Duncan – 1 August 2013, Build 137, Feature article
Stainless claddings can have a very low corrosion rate and remain functional over the life of the structure. But each stainless steel grade is a little different, so specify and use them appropriately.
By Charissa Snijders – 1 April 2010, Build 117
This Pathfinder project at Victoria University of Wellington looks at a team approach to getting a façade right first time by considering quality and value over cost.
By Alide Elkink – 1 June 2012, Build 130
A Build reader recently asked if H3.1 treatment for timber cladding is sufficient to protect against rot. It is, but only if primed before installation, painted and regularly maintained.
By Trevor Pringle – 1 October 2012, Build 132
The junctions between different cladding materials can present a few challenges for designers. BRANZ has developed some details to help fill the gap.
By Alide Elkink – 1 April 2013, Build 135
The range of flexible wall underlays available can make choosing an appropriate one difficult. So what are the options and how do you select the correct wall underlay?
By Nigel Isaacs – 1 April 2013, Build 135
Census Data gives us a picture of the materials used in the past for claddings and structure. Although what we know has been limited, the dominance of timber framing is clear.
By Alide Elkink – 1 December 2013, Build 139
Well located movement control joints are essential in plaster claddings to avoid random cracking that can compromise weathertightness.
By Eddie Bruce – 1 December 2003, Build 79
When preservative-treated timber is cut, shaped, planed or drilled, the newly revealed timber may not be protected by preservative and end grain may be exposed. Additional treatment may be needed to protect the cut ends.
By John O’Donnell – 1 April 2005, Build 87
On the surface, profiled metal as a sheet wall cladding should be a straightforward option, after all it’s been used successfully on roofs for years. However, when used on walls it poses its own set of unique challenges.
By Stephen Sargent – 1 April 2007, Build 99
A wall or roof underlay is very different from a vapour barrier. One lets moisture through and out of a building and the other doesn’t. Using the wrong one will trap moisture where you don’t want it.