Edge detailing for membrane roofs
Don’t be misled into thinking that rubber roofing membranes can do without edge detailing. It’s required in E2/AS1, and omitting it can lead to stained walls.
This website is best viewed on a newer browser than the one you are using. Learn about upgrading your browser (opens in a new window/tab)
Welcome to BRANZ Build. Skip to main content.
Showing results 1-8 of 8
Order by:
Don’t be misled into thinking that rubber roofing membranes can do without edge detailing. It’s required in E2/AS1, and omitting it can lead to stained walls.
NZS 3604:2011 Timber-framed buildings sets out how to size rafters in table 10.1. The BRANZ technical helpline has received queries on doing this, so let’s step through some examples.
We complete this four-part Build series on calculating bracing requirements by looking at roof bracing.
Verge overhangs are the areas of a timber-framed roof that are most vulnerable to wind damage, so it’s important to get them right.
Good detailing of the roof wall junction for lean-tos is important for the weathertightness of a building, but this junction can present some challenges.
The roof on a new building needs to be more than just aesthetically appealing and able to keep the building weathertight – it must also effectively collect and dispose of rainwater.
Good roof system design is a critical part of a good building. A roof designer must consider cost, performance and appearance, but it’s important to keep a few other factors in mind.
Designers should be designing roofs with enough space between the roof underlay and top plate for the thicker ceiling insulation now commonly used. Here are some options to avoid getting caught short.